|Home » Categories » Entry Solutions » Garage Door Operators » Specific Garage Door Openers By Brand and or Model » Linear LDO/LSO/LCO|
How do I program my car’s Homelink system to operate my Linear garage door operator?
Article Number: 321 | Rating: 2.7/5 from 48 votes | Last Updated: Tue, Nov 20, 2012 at 12:56 PM
The HomeLink system copies a transmitter that has already been learned into your Linear garage door operator's memory. To learn the transmitter into Homelink, take the transmitter into your car. Press and hold the Homelink button in the car. Press and hold the button on the transmitter that is currently programmed to open your door for 8 to 9 seconds, release only the transmitter button, and immediately press and hold for 8 to 9 seconds. Repeat four to five times, (holding the HomeLink button all of the time) or until Homelink signals that it has learned the code from the transmitter.
There are no attachments for this article.
Why will the remote open my Linear garage door operator, but not close it?
Viewed 23807 times since Tue, Mar 30, 2010
Can I add a second wall button to my LDO/LSO/LCO series operator?
Viewed 2442 times since Mon, Apr 19, 2010
How do I learn a transmitter into my LDCO800?
Viewed 3395 times since Tue, Apr 5, 2011
How do I program my transmitter to my Linear garage door operator?
Viewed 39260 times since Mon, Mar 29, 2010
The remotes will not open my garage door operator from inside or outside the garage, but the remotes will close it. The wall button works correctly.
Viewed 11193 times since Tue, Apr 5, 2011
How do I set the travel limits on my Linear garage door operator?
Viewed 3679 times since Fri, Mar 26, 2010
How do I find the serial number of my LDO/LSO/LCO operator?
Viewed 2421 times since Thu, Jul 7, 2011
What transmitter (hand held remote) and keypad will work with my Linear garage door operator?
Viewed 14711 times since Fri, Mar 26, 2010
How do I change the keypad code for my Linear garage door operator?
Viewed 76647 times since Tue, Jul 12, 2011
How do I change the keypad code on my LDO/LSO/LCO operator with serial number after 20100915XXXXX?
Viewed 3396 times since Tue, Apr 5, 2011