Backup power supply for select gate operators, gate opens on power outage.
The SPS-50 Gate Operator Standby Power Supply, Fail Safe is designed to provide back-up power to a gate operator when the main AC supply voltage is interrupted or disconnected. It eliminates the need for a separate motor and control circuit to be mechanically attached to the gate operator. The SPS-50 will provide the power and a signal to the gate operator to open the gate and leave it open until the main power is restored. Once the main power is restored, the SPS-50 will provide a signal to the gate operator and the operator will close (if a timer to close is used). It is not designed to continuously cycle the gate operator. Many local building codes require this type open only back-ups vs. a continuous cycle back-up.
The SPS-50 consists of control box and a battery pack. The SPS-50 control box senses the main power, charges the battery pack, converts the DC battery voltage to AC voltage (to power the operator) and provides control signals to activate the operator when the main power is interrupted. Additionally, the SPS-50 control box has a set of relay outputs that are activated if a low battery capacity is detected. These contacts may be connected to an alarm system to alert the end user that battery maintenance is required.
Order number: 190-107633
|INPUT VOLTAGE: 105-125VAC||OUTPUT VOLTAGE: 115 VAC ± 10%|
|SURGE PROTECTION: MOV. TRANZORB||OUTPUT FREQUENCY: 60 HZ|
|BATTERY: 24 VDC, 7 AH||OUTPUT CURRENT: 5 AMPS|
|RECHARGE TIME: 8 HOURS||SURGE CURRENT: 9 AMPS|
|OUTPUT POWER: 500 WATTS|
|SURGE POWER 1,000 WATTS|
|CONTROL RELAY OUTPUT: DPDT, 2 AMPS|