GT SERIES: Extra Heavy-Duty Gear Reduced Drawbar Commercial Door Operator

Installation and Owner’s Manual –
(Post 2010 UL requirements)
Flyer/Architectural Spec
Fraba Safety Devices Brochure

The GT SERIES – Extra heavy-duty gear reduced drawbar commercial door operator (for standard lift sectional doors) series, available in 1/2, 3/4, and 1 horsepower, various supply voltages and phases. Not to exceed 35 cycles per hour, 150+ cycles per day.

Ratings

• Maximum duty cycle: 35 cycles per hour, 150+ cycles per day
• Maximum door height: 22-1/2 feet

Features

• Solid state control circuit 
• Constant pressure required to close if no entrapment devices are installed 
• All steel frame
• Oil bath gear reduction unit
• Quick disconnect door arm for manual door operation
• #41 roller chain drive
• Standard door speed approximately 11 inches per second
• Adjustable torque converter
• Solenoid brake standard
• Motor overload protection
• Wired to accept reversing devices
• Internally adjustable limit switches
• High starting torque, continuous duty motor
• TEFC Motor standard on single phase 1 HP and over, and all 3 phase operators
• 24-Volt control circuit with OPEN, CLOSE and STOP 3-button station
• OPEN button (and single button) will automatically override down travel and reverse door to the full open position
• External terminals for single button (residential type) radio control

Rail Options

• Rail for up to 14′ 6″ high doors
• Rail for up to 16′ 6″ high doors
• Rail for up to 18′ 6″ high doors
• Rail for up to 20′ 6″ high doors
• Rail for up to 22′ 6″ high doors

Common Options

• Linear Photo Beam Kit: HAE00056
• MVP-MR 3-channel open-close-stop modular receiver installed: P/N 2650-159

Warranty

• 2 years